Posted on April 26, 2019April 26, 2019 by tinkerBOY — 1 CommentWiring Guide for the tinkerBOY Add-on Board Wiring the tinkerBOY Add-On Board for the tinkerBOY Controller v3. Post navigationPrevious post: tinkerBOY PowerSwitch v1.0 Prototype #2 and Add-On BoardsNext post: Raspberry Pi 3: Wire It Directly From The Power Supply 1 thought on “Wiring Guide for the tinkerBOY Add-on Board” Matthew Brantner April 27, 2020 how can the input on the controller board go to the input on the add on board? same with output. shouldn’t the out on the controller board go to the input on the addon? then the output on the addon go to the input on the controller board? Reply Leave a Reply Cancel replyYour email address will not be published. Required fields are marked *Comment * Name * Email * Website Save my name, email, and website in this browser for the next time I comment. Δ This site uses Akismet to reduce spam. Learn how your comment data is processed.