Posted on 7 Comments

How to Wire the L and R buttons

Use the diagram below to wire the tactile switches for the L and R shoulder buttons. You can wire the GND to any GND pins on the board or any GND somewhere else like from the Raspberry Pi, Battery, powerboost, etc…

For v3.0:

 

For v1.1, v1.2, v2.1, and v2.2:

Just do the same wiring if you want to add the L2 and R2 buttons.

7 thoughts on “How to Wire the L and R buttons

  1. What about ZL and ZR (L2 and R2)?

  2. What do I wire ground to on 2.2?

  3. You wire those to the L2 and R2 pads, just under the L1 and R1 pads.

  4. For the 2.1 what GND pads should I use?

    1. You can use any GND as they are all the same and connected.

  5. can a L2 and R2 be wired up on the tinkerBOY Controller v3.0 and if so how would one do this?

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.